Prepare for path MTU discovery by splitting up the concept of
DefaultMTU() into the concepts of the Tailscale TUN MTU, MTUs of
underlying network interfaces, minimum "safe" TUN MTU, user configured
TUN MTU, probed path MTU to a peer, and maximum probed MTU. Add a set
of likely MTUs to probe.
Updates #311
Signed-off-by: Val <valerie@tailscale.com>
Prepare for path MTU discovery by splitting up the concept of
DefaultMTU() into the concepts of the Tailscale TUN MTU, MTUs of
underlying network interfaces, minimum "safe" TUN MTU, user configured
TUN MTU, probed path MTU to a peer, and maximum probed MTU. Add a set
of likely MTUs to probe.
Updates #311
Signed-off-by: Val <valerie@tailscale.com>
Replace CanPMTUD() with ShouldPMTUD() to check if peer path MTU discovery should
be enabled, in preparation for adding support for enabling/disabling peer MTU
dynamically.
Updated #311
Signed-off-by: Val <valerie@tailscale.com>
Add an enable/disable argument to setDontFragment() in preparation for dynamic
enable/disable of peer path MTU discovery. Add getDontFragment() to get the
status of the don't fragment bit from a socket.
Updates #311
Co-authored-by: James Tucker <james@tailscale.com>
Signed-off-by: Val <valerie@tailscale.com>
Use IPV6_MTU_DISCOVER for setting don't fragment on IPv6 sockets on Linux (was
using IP_MTU_DISCOVER, the IPv4 arg).
Updates #311
Signed-off-by: Val <valerie@tailscale.com>
Make the debugknob variable name for enabling peer path MTU discovery match the
env variable name.
Updates #311
Signed-off-by: Val <valerie@tailscale.com>
And convert all callers over to the methods that check SelfNode.
Now we don't have multiple ways to express things in tests (setting
fields on SelfNode vs NetworkMap, sometimes inconsistently) and don't
have multiple ways to check those two fields (often only checking one
or the other).
Updates #9443
Change-Id: I2d7ba1cf6556142d219fae2be6f484f528756e3c
Signed-off-by: Brad Fitzpatrick <bradfitz@tailscale.com>
NetworkMap.Addresses is redundant with the SelfNode.Addresses. This
works towards a TODO to delete NetworkMap.Addresses and replace it
with a method.
This is similar to #9389.
Updates #cleanup
Change-Id: Id000509ca5d16bb636401763d41bdb5f38513ba0
Signed-off-by: Brad Fitzpatrick <bradfitz@tailscale.com>
LocalBackend can talk to magicsock on its own to do this without
the "Engine" being involved.
(Continuing a little side quest of cleaning up the Engine
interface...)
Updates #cleanup
Change-Id: I8654acdca2b883b1bd557fdc0cfb90cd3a418a62
Signed-off-by: Brad Fitzpatrick <bradfitz@tailscale.com>
Currently only the top four most popular changes: endpoints, DERP
home, online, and LastSeen.
Updates #1909
Change-Id: I03152da176b2b95232b56acabfb55dcdfaa16b79
Signed-off-by: Brad Fitzpatrick <bradfitz@tailscale.com>
We're trying to start using that monster type less and eventually get
rid of it.
Updates #1909
Change-Id: I8e1e725bce5324fb820a9be6c7952767863e6542
Signed-off-by: Brad Fitzpatrick <bradfitz@tailscale.com>
This is both more efficient (because the knobs' bool is only updated
whenever Node is changed, rarely) and also gets us one step closer to
removing a case of storing a netmap.NetworkMap in
magicsock. (eventually we want to phase out much of the use of that
type internally)
Updates #1909
Change-Id: I37e81789f94133175064fdc09984e4f3a431f1a1
Signed-off-by: Brad Fitzpatrick <bradfitz@tailscale.com>
Previously two tsnet nodes in the same process couldn't have disjoint
sets of controlknob settings from control as both would overwrite each
other's global variables.
This plumbs a new controlknobs.Knobs type around everywhere and hangs
the knobs sent by control on that instead.
Updates #9351
Change-Id: I75338646d36813ed971b4ffad6f9a8b41ec91560
Signed-off-by: Brad Fitzpatrick <bradfitz@tailscale.com>
In prep for incremental netmap update plumbing (#1909), make peerMap
also keyed by NodeID, as all the netmap node mutations passed around
later will be keyed by NodeID.
In the process, also:
* add envknob.InDevMode, as a signal that we can panic more aggressively
in unexpected cases.
* pull two moderately large blocks of code in Conn.SetNetworkMap out
into their own methods
* convert a few more sets from maps to set.Set
Updates #1909
Change-Id: I7acdd64452ba58e9d554140ee7a8760f9043f961
Signed-off-by: Brad Fitzpatrick <bradfitz@tailscale.com>
I didn't clean up the more idiomatic map[T]bool with true values, at
least yet. I just converted the relatively awkward struct{}-valued
maps.
Updates #cleanup
Change-Id: I758abebd2bb1f64bc7a9d0f25c32298f4679c14f
Signed-off-by: Brad Fitzpatrick <bradfitz@tailscale.com>
Replace %w verb with %v verb when logging errors.
Use %w only for wrapping errors with fmt.Errorf()
Fixes: #9213
Signed-off-by: Craig Rodrigues <rodrigc@crodrigues.org>
I'm not saying it works, but it compiles.
Updates #5794
Change-Id: I2f3c99732e67fe57a05edb25b758d083417f083e
Signed-off-by: Brad Fitzpatrick <bradfitz@tailscale.com>
Upcoming work on incremental netmap change handling will require some
replumbing of which subsystems get notified about what. Done naively,
it could break "tailscale status --json" visibility later. To make sure
I understood the flow of all the updates I was rereading the status code
and realized parts of ipnstate.Status were being populated by the wrong
subsystems.
The engine (wireguard) and magicsock (data plane, NAT traveral) should
only populate the stuff that they uniquely know. The WireGuard bits
were fine but magicsock was populating stuff stuff that LocalBackend
could've better handled, so move it there.
Updates #1909
Change-Id: I6d1b95d19a2d1b70fbb3c875fac8ea1e169e8cb0
Signed-off-by: Brad Fitzpatrick <bradfitz@tailscale.com>
If we don't have the ICMP hint available, such as on Android, we can use
the signal of rx traffic to bias toward a particular endpoint.
We don't want to stick to a particular endpoint for a very long time
without any signals, so the sticky time is reduced to 1 second, which is
large enough to avoid excessive packet reordering in the common case,
but should be small enough that either rx provides a strong signal, or
we rotate in a user-interactive schedule to another endpoint, improving
the feel of failover to other endpoints.
Updates #8999
Co-authored-by: Charlotte Brandhorst-Satzkorn <charlotte@tailscale.com>
Signed-off-by: James Tucker <james@tailscale.com>
Signed-off-by: Charlotte Brandhorst-Satzkorn <charlotte@tailscale.com>
There are cases where we do not detect the non-viability of a route, but
we will instead observe a failure to send. In a Disco path this would
normally be handled as a side effect of Disco, which is not available to
non-Disco WireGuard nodes. In both cases, recognizing the failure as
such will result in faster convergence.
Updates #8999
Signed-off-by: James Tucker <james@tailscale.com>
LastFullPing is now used for disco or wireguard only endpoints. This
change updates the comment to make that clear.
Updates #7826
Signed-off-by: Charlotte Brandhorst-Satzkorn <charlotte@tailscale.com>
There are latency values stored in bestAddr and endpointState that are
no longer applicable after a connectivity change and should be cleared
out, following the documented behavior of the function.
Updates #8999
Signed-off-by: James Tucker <james@tailscale.com>
When sending a ping from the CLI, only accept a pong that is in reply
to the specific CLI ping we sent.
Updates #311
Signed-off-by: Val <valerie@tailscale.com>
Now a nodeAttr: ForceBackgroundSTUN, DERPRoute, TrimWGConfig,
DisableSubnetsIfPAC, DisableUPnP.
Kept support for, but also now a NodeAttr: RandomizeClientPort.
Removed: SetForceBackgroundSTUN, SetRandomizeClientPort (both never
used, sadly... never got around to them. But nodeAttrs are better
anyway), EnableSilentDisco (will be a nodeAttr later when that effort
resumes).
Updates #8923
Signed-off-by: Brad Fitzpatrick <bradfitz@tailscale.com>
To record wether user is using iptables or nftables after we add support to nftables on linux, we
are adding a field FirewallMode to NetInfo in HostInfo to reflect what firewall mode the host is
running, and form metrics. The information is gained from a global constant in hostinfo.go. We
set it when selection heuristic made the decision, and magicsock reports this to control.
Updates: tailscale/corp#13943
Signed-off-by: KevinLiang10 <kevinliang@tailscale.com>
If a node is flapping or otherwise generating lots of STUN endpoints, we
can end up caching a ton of useless values and sending them to peers.
Instead, let's apply a fixed per-Addr limit of endpoints that we cache,
so that we're only sending peers up to the N most recent.
Updates tailscale/corp#13890
Signed-off-by: Andrew Dunham <andrew@du.nham.ca>
Change-Id: I8079a05b44220c46da55016c0e5fc96dd2135ef8
Netcheck no longer performs I/O itself, instead it makes requests via
SendPacket and expects users to route reply traffic to
ReceiveSTUNPacket.
Netcheck gains a Standalone function that stands up sockets and
goroutines to implement I/O when used in a standalone fashion.
Magicsock now unconditionally routes STUN traffic to the netcheck.Client
that it hosts, and plumbs the send packet sink.
The CLI is updated to make use of the Standalone mode.
Fixes#8723
Signed-off-by: James Tucker <james@tailscale.com>
This sets the Don't Fragment flag, for now behind the
TS_DEBUG_ENABLE_PMTUD envknob.
Updates #311.
Signed-off-by: Val <valerie@tailscale.com>
Signed-off-by: salman <salman@tailscale.com>
This adds the capability to pad disco ping message payloads to reach a
specified size. It also plumbs it through to the tailscale ping -size
flag.
Disco pings used for actual endpoint discovery do not use this yet.
Updates #311.
Signed-off-by: salman <salman@tailscale.com>
Co-authored-by: Val <valerie@tailscale.com>
The nonce value is not read by anything, and di.sharedKey.Seal()
a few lines below generates its own. #cleanup
Signed-off-by: salman <salman@tailscale.com>
This change removes the noV4/noV6 check from addrForSendWireGuardLocked.
On Android, the client panics when reaching `rand.Intn()`, likely due to
the candidates list being containing no candidates. The suspicion is
that the `noV4` and the `noV6` are both being triggered causing the
loop to continue.
Updates tailscale/corp#12938
Updates #7826
Signed-off-by: Charlotte Brandhorst-Satzkorn <charlotte@tailscale.com>
Jordan Whited
James Tucker
Val
Brad Fitzpatrick
Craig Rodrigues
Charlotte Brandhorst-Satzkorn
KevinLiang10
Andrew Dunham
salman aljammaz
David Anderson