There is utility in logging traffic statistics that occurs at the physical layer.
That is, in order to send packets virtually to a particular tailscale IP address,
what physical endpoints did we need to communicate with?
This functionality logs IP addresses identical to
what had always been logged in magicsock prior to #5823,
so there is no increase in PII being logged.
ExtractStatistics returns a mapping of connections to counts.
The source is always a Tailscale IP address (without port),
while the destination is some endpoint reachable on WAN or LAN.
As a special case, traffic routed through DERP will use 127.3.3.40
as the destination address with the port being the DERP region.
This entire feature is only enabled if data-plane audit logging
is enabled on the tailnet (by default it is disabled).
Example of type of information logged:
------------------------------------ Tx[P/s] Tx[B/s] Rx[P/s] Rx[B/s]
PhysicalTraffic: 25.80 3.39Ki 38.80 5.57Ki
100.1.2.3 -> 143.11.22.33:41641 15.40 2.00Ki 23.20 3.37Ki
100.4.5.6 -> 192.168.0.100:41641 10.20 1.38Ki 15.60 2.20Ki
100.7.8.9 -> 127.3.3.40:2 0.20 6.40 0.00 0.00
Signed-off-by: Joe Tsai <joetsai@digital-static.net>
The netlog.Message type is useful to depend on from other packages,
but doing so would transitively cause gvisor and other large packages
to be linked in.
Avoid this problem by moving all network logging types to a single package.
We also update staticcheck to take in:
003d277bcf
Signed-off-by: Joe Tsai <joetsai@digital-static.net>
This sets up Logger to handle statistics at the magicsock layer,
where we can correlate traffic between a particular tailscale IP address
and any number of physical endpoints used to contact the node
that hosts that tailscale address.
We also export Message and TupleCounts to better document the JSON format
that is being sent to the logging infrastructure.
This commit does NOT yet enable the actual logging of magicsock statistics.
That will be a future commit.
Signed-off-by: Joe Tsai <joetsai@digital-static.net>
If the wgcfg.Config is specified with network logging arguments,
then Userspace.Reconfig starts up an asynchronous network logger,
which is shutdown either upon Userspace.Close or when Userspace.Reconfig
is called again without network logging or route arguments.
Signed-off-by: Joe Tsai <joetsai@digital-static.net>
The Logger type managers a logtail.Logger for extracting
statistics from a tstun.Wrapper.
So long as Shutdown is called, it ensures that logtail
and statistic gathering resources are properly cleared up.
Signed-off-by: Joe Tsai <joetsai@digital-static.net>
Joe Tsai