Run `staticcheck` with `U1000` to find unused code. This cleans up about
a half of it. I'll do the other half separately to keep PRs manageable.
Updates #cleanup
Signed-off-by: Andrew Lytvynov <awly@tailscale.com>
The current structure meant that we were embedding netstack in
the tailscale CLI and in the GUIs. This removes that by isolating
the checksum munging to a different pkg which is only called from
`net/tstun`.
Fixes#9756
Signed-off-by: Maisem Ali <maisem@tailscale.com>
Implements the ability for the address-rewriting code to support rewriting IPv6 addresses.
Specifically, UpdateSrcAddr & UpdateDstAddr.
Signed-off-by: Tom DNetto <tom@tailscale.com>
Updates https://github.com/tailscale/corp/issues/11202
This updates all source files to use a new standard header for copyright
and license declaration. Notably, copyright no longer includes a date,
and we now use the standard SPDX-License-Identifier header.
This commit was done almost entirely mechanically with perl, and then
some minimal manual fixes.
Updates #6865
Signed-off-by: Will Norris <will@tailscale.com>
01b90df2fa added SCTP support before
(with explicit parsing for ports) and
69de3bf7bf tried to add support for
arbitrary IP protocols (as long as the ACL permited a port of "*",
since we might not know how to find ports from an arbitrary IP
protocol, if it even has such a concept). But apparently that latter
commit wasn't tested end-to-end enough. It had a lot of tests, but the
tests made assumptions about layering that either weren't true, or
regressed since 1.20. Notably, it didn't remove the (*Filter).pre
bidirectional filter that dropped all "unknown" protocol packets both
leaving and entering, even if there were explicit protocol matches
allowing them in.
Also, don't map all unknown protocols to 0. Keep their IP protocol
number parsed so it's matchable by later layers. Only reject illegal
things.
Fixes#6423
Updates #2162
Updates #2163
Change-Id: I9659b3ece86f4db51d644f9b34df78821758842c
Signed-off-by: Brad Fitzpatrick <bradfitz@tailscale.com>
The fragment offset is an 8 byte offset rather than a byte offset, so
the short packet limit is now in fragment block size in order to compare
with the offset value.
The packet flags are in the first 3 bits of the flags/frags byte, and
so after conversion to a uint16 little endian value they are at the
start, not the end of the value - the mask for extracting "more
fragments" is adjusted to match this byte.
Extremely short fragments less than 80 bytes are dropped, but fragments
over 80 bytes are now accepted.
Fixes#5727
Signed-off-by: James Tucker <james@tailscale.com>
There are a few remaining uses of testing.AllocsPerRun:
Two in which we only log the number of allocations,
and one in which dynamically calculate the allocations
target based on a different AllocsPerRun run.
This also allows us to tighten the "no allocs"
test in wgengine/filter.
Signed-off-by: Josh Bleecher Snyder <josh@tailscale.com>
Add proto to flowtrack.Tuple.
Add types/ipproto leaf package to break a cycle.
Server-side ACL work remains.
Updates #1516
Signed-off-by: Brad Fitzpatrick <bradfitz@tailscale.com>
This adds a new IP Protocol type, TSMP on protocol number 99 for
sending inter-tailscale messages over WireGuard, currently just for
why a peer rejects TCP SYNs (ACL rejection, shields up, and in the
future: nothing listening, something listening on that port but wrong
interface, etc)
Updates #1094
Updates tailscale/corp#1185
Signed-off-by: Brad Fitzpatrick <bradfitz@tailscale.com>
The packet filter still rejects all IPv6, but decodes enough from v6
packets to do something smarter in a followup.
name time/op
Decode/tcp4-8 28.8ns ± 2%
Decode/tcp6-8 20.6ns ± 1%
Decode/udp4-8 28.2ns ± 1%
Decode/udp6-8 20.0ns ± 6%
Decode/icmp4-8 21.7ns ± 2%
Decode/icmp6-8 14.1ns ± 2%
Decode/unknown-8 9.43ns ± 2%
Signed-off-by: David Anderson <danderson@tailscale.com>
Brad Fitzpatrick
Andrew Lytvynov
Maisem Ali
Tom DNetto
Will Norris
James Tucker
Josh Bleecher Snyder
David Anderson
Dmytro Shynkevych